Total Pageviews

Friday, June 24, 2011

Term 2 Week 9

It is finished. Here is how it came out.

Term 2 Week 8

I have put 2 coats of finish on this week, with a light sanding with wet and dry in between coats. This kept the finished job nice and smooth.

I am using this clear finish on my kitchen rack. It highlights the grain of the wood, but because it is water based, the brushes are easy to clean with water.

Term 2 Week 7

This week I sanded the whole job clean, removed all pencil marks and scratches using glass paper and a sanding cork.

Tuesday, June 7, 2011

Term 2 Week 6

I glued 2 pieces of 42 x 19 meranti together, this will be for my woodturning.
I then turned it as shown below, making sure the diameter would fit in my drilled holes.
This is how it looks now.

Sunday, June 5, 2011

Term 2 Week 5

I have finished my drawer.
octagonal handle
I made an octagonal shaped handle (I planed the corners of a square piece) and just glued and clamped it in place.



Here is how it all looks together.
My last step is to do the turned piece.

Friday, May 27, 2011

Term 2 Week 5



I have glued the frame together and attached a small piece of 19 x 12 x 238 to the back of the frame.  This is instead of a back, I can use it to put screws through if I decide to mount it upside down on the wall (as shown below).  It will also stop the drawer sliding right through if I leave it sitting on a bench. I had to adjust the size of my drawer to only 103mm deep, this will leave it flush at the front when the drawer is fully in.



I have also made the drawer (as shown below). I just glued and clamped it so that there weren't any nails visible from the front.
Exploded drawer

Finished drawer