I have glued the frame together and attached a small piece of 19 x 12 x 238 to the back of the frame. This is instead of a back, I can use it to put screws through if I decide to mount it upside down on the wall (as shown below). It will also stop the drawer sliding right through if I leave it sitting on a bench. I had to adjust the size of my drawer to only 103mm deep, this will leave it flush at the front when the drawer is fully in.
I have also made the drawer (as shown below). I just glued and clamped it so that there weren't any nails visible from the front.
 |
| Exploded drawer |
 |
| Finished drawer |
No comments:
Post a Comment